Reinstall the plate and test the dead bolt.
Adjust door strike plate.
6 fill the gap between the strike plate and the door jamb with wood.
Adjust strike plates to close doors securely.
Turn the latch to draw in the bolt close the door and turn the latch again so the bolt hits the strike plate.
The strike plate is the piece of door hardware that attaches to the door jamb and receives the latch.
Then reinstall the plate with longer screws.
Have a door out of alignment due to settling.
Thankfully the door latches and knobs don t have to be moved to correct these problems.
If your filing action is shaking the strike plate remove the plate and secure it in a vise for your repair.
Move it away from the center if the strike will not seat when the door is closed.
Skip to main content.
Gatehouse steel entry door deadbolt strike plate.
Unscrew the strike plate from the door jamb clamp it in a vise then file it down to the chalk mark above right.
For minor adjustments you may be able to loosen the plate and tap it in the direction you need.
Insert either a triangular file or a flat file that s small enough to fit inside the strike plate.
Find a store near me.
Use a screwdriver to loosen the screws slightly.
Latches that don t fit properly into these plates will allow doors to rattle or prevent them from closing.
For pricing and availability.
First shut the door and take a look at how far off the strike plate is in order for the latch barrel to align with the plate hole.
If it only misses by 1 8 inch or less the problem can likely be solved by tapping the plate in the right direction with a hammer.
The stripped hole repair kit from king s original ha.
Open the door and look for a telltale kiss on the strike plate.
Typically if you loosen both screws 1 2 full counterclockwise turns with your screwdriver or allen wrench the strike plate will be free to adjust.
Find strike plates at lowe s today.
File off enough metal to allow the latch to catch inside the plate and secure the door.
Loosen the screws a bit more if necessary but don t remove them completely.
Screw the strike plate to the jamb then re bend the tab into the latch pocket by tapping it with a screwdriver and hammer.
Gatehouse steel entry door strike plate.
